Rust-Oleum 241352 Parks Super Glaze Pour-On Finish & Preservative, Clear, 32 Oz

Achieve an ultra-thick, ultra-glossy, waterproof finish instantly with Rust-Oleum Parks Super Glaze Pour-On Finish and Preservative. Just one pour of this crystal-clear epoxy is as thick as 75 coats of varnish. Parks Super Glaze Pour on Finish & Preservative is an ultra thick high gloss clear epoxy that provides exceptional durability. Ideal as a waterproof finish for table and bar tops, it is also great for crafts and furniture refinishing. Super Glaze can be used over almost any interior surface; from rough and unfinished to stained, painted or smooth surfaces. Perfect for bar tops, kitchen islands and more. Recommended for indoor use only and is not recommended for use on wood floors.

• Size: 32 ounce
• Clear gloss finish
• One pour is as thick as 75 coats of varnish
• Ideal as a waterproof protective finish for tables and bar tops
• Use to encase almost anything coins, pictures, shells and more
• Covers 6.4 sq. ft.
• Cleans up with mineral spirits
• Resists water, heat and chemicals
• Pours on for ease of use
• Simple to use - 1:1 mixing ratio
• Pour on finish and preservative in ultra-thick high-gloss, crystal-clear epoxy that provides maximum durability and see-through
• Ideal for furniture, tabletops, bars, game boards, clocks, plaques and ceramics.

Packaging:

Super Glaze is available in a 1 quart kit (0.95 liters)

• 1-Pint Part A: Base - 16 fluid ounces (0.47 liters)
• 1-Pint Part B: Activator - 16 fluid ounces (0.47 liters)

Required Tools:

• Disposable mixing cups or buckets with volume measurements
• Stir sticks or paint paddles (not power assisted)
• Plastic spreader or squeegee
• Masking Tape
• Small disposable paint brush for edge work.
• Latex, vinyl or chemical resistant gloves
• Plastic drop cloth, newspaper or waxed paper
• Level
• Eye protection

Surface Prep:

• Clean with alcohol or acetone, allow to dry
• Tape off sides and edges of item
• Seal with clear coat before use on porous surfaces
• Lightly sand and remove sanding dust prior to use over polyurethane or acrylic finishes

Mix & Pour:

• Measure equal parts of A & B separately
• Pour Part A into Part B
• Stir gently & thoroughly for 3-5 minutes
• Transfer mixed product to clean container
• Stir product another 3 minutes
• Pour mixture into center of work area
• Spread in one direction with spreader
• Use hair dryer on low speed to remove bubbles
• Dries to touch in 4-5 hours
• Fully cured in 72 hours.

Tips & Tricks:

• Measure Exact 1:1 ratio of parts A & B
• Activates upon mixing - pot life is 20-25 min - mix one kit at a time
• Remove bubbles on surface while wet
• Stop spreading material once it starts to dry
• Do not shake or use power mixer
• Keep project free from dust & debris a minimum of 8 hours after application
• Not for use on wood floors
• Indoor use only - not for exterior surfaces
• Return thick unmixed material to normal by running hot water over sealed container
• If applying more than one coat, wipe surface with alcohol or acetone between coats